RE-PROGRAMMING INSTRUCTIONS

1. With the headset turned OFF, swing the microphone back, and insert into the programming station with its programming window facing toward the programming cable jackets.

2. Turn the headset ON. The indicator LED flashes, indicating that programming is complete.

RE-PROGRAMMING INSTRUCTIONS

1. Plug the programming cable into base station.

The programming cable on the C960 model is about 3' long with a modular connector on one end and a flat 4-pin connector on the other end.

2. With the unit turned ON, plug the cable into the unit's programming port.

3. When programming tone is heard, unplug the cable from C960/860/1025.

4. Your unit is now fully programmed and ready for use.

5. Repeat steps 1-4 for additional repaired units.

TERMS
•Half Duplex:
Combined speaker and mic at the menu board

•Full Duplex:
Separate speaker and mic at the menu board

•Hands-Free:
Automatic two-way communication (Talk and Listen) without touching the belt pack again (Operartes in Full Duplex system only).

POWER ON
•Slide battery cover off, insert battery, slide battery cover on
•Rotate on/volume control knob clockwise; power light goes on

OPERATING MODES
1. Hands-free DISABLED mode
•Press and hld "A" button to talk to customer; release to listen
•To talk to the customer again or to the next customer, press and hold the "A" button; release to listen
•When vehicle exits, system becomes silent

2. Hands-free ENABLED mode:
•Press "A" button once to automatically Talk and Listen to customer (Power light blinks continuously in this mode)
•When vehicle exits, the system becomes silent, but outbound audio will still be heard
•Hands-free is turned off when either the "A" or "B" button is pressed, or the belt pack is turned off

NOTE: After a vehicle exits the drive-thru area, the inbound audio mutes. When the next car arrives, the vehicle-present tone is heard in the headset and two-way communication with the customer can begin.

To communicate with other personnel wearing Belt Packs without being heard by the customer:
• Press the "B" button and speak
• Release the "B" button immediately after speaking since the "B" channel overrides the "A" channel and will
cut out any ongoing communication with the customer.